Description
March Pump’s industrial LC-3M-MD is an American submersible seal-less centrifugal magnetic drive pump. It is capable of generating a maximum flow of 8.5 gallons per minute at 4 feet, and its maximum head is 19 Feet (8PSI). It is capable of 24,000 BTU a hour. The LC-3M-MD pump may be used submerged or not submerged. The standard wet end (the materials that come into contact with the solution) is composed of Polypropylene, Buna N, Cupric Nickel, Carbon, Ceramic, and Ceramic Magnet. When submerged, Epoxy, Stainless Steel, Polysulfone, and the Cord are also in contact with the solution. The inlet connection is 3/4 inch female pipe thread, and the outlet is 1/2 inch male pipe thread. The standard motor is a 1 Phase 115V or 230V 0.05 Horsepower motor, which can be run on either 50 or 60 hertz (there are performance differences between the hertz options). The maximum internal pressure the pump can tolerate is 25PSI, and the maximum liquid temperature is 130 Fahrenheit or 54 Celsius.
The pump is Ignition Protected per SAE J1171 and ISO 8846. The impeller has a carbon bushing allowing the pump to run dry longer before suffering damage.
System: 60Hz
US Metric
Max Flow: 8.5 GPM 32.2 LPM
Max Head: 19 FT 5.8 M
Power: 0.05 HP 0.037 KW
System: 50Hz
US Metric
Max Flow: 8.2 GPM 31 LPM
Max Head: 14.1 FT 4.3 M
Power: 0.05 HP 0.037 KW
Electrical/Air: 115V 50/60Hz or 230V 50/60Hz
Inlet: 3/4″FPT
Outlet: 1/2″MPT
Submersible: Yes
Wet End: Polypropylene (Front and Rear Housing, Impeller), Cupric Nickel (Cooling Tube), Buna N (O-Ring, Cooling Tube Seal), Carbon (Impeller Bushing) Ceramic (Shaft, Thrust Washer), Ceramic Magnet
Uses: Submersible or Open Air
When submerged, the following is also in contact with the solution: Epoxy, Stainless Steel, Polysulfone, Cord
Max Internal Pressure: 25 PSI / 1.7 bar
Max Liquid Temperature: 130 °F / 54 °C
Ignition Protected per SAE J1171 and ISO 8846: Rated IP 67
UL Listed Motor:
Note: Product image may be different than actual product received.
